Skip to main navigation menu Skip to main content Skip to site footer

Articles

Vol. 11 No. 6 (2026): Kohesi: Jurnal Sains dan Teknologi, ISSN 3025-1311

ANALISIS KINERJA STRUKTUR GEDUNG TUJUH LANTAI MENGGUNAKAN SISTEM GANDA TERHADAP BEBAN GEMPA

Submitted
November 9, 2026
Published
2026-11-09

Abstract

Indonesia merupakan wilayah dengan aktivitas seismik tinggi sehingga perencanaan gedung bertingkat harus memperhatikan ketahanan terhadap beban gempa. Penelitian ini bertujuan menganalisis kinerja struktur gedung perkantoran tujuh lantai menggunakan Sistem Rangka Pemikul Momen Khusus (SRPMK) dan Sistem Ganda dengan dinding geser (shear wall), menentukan konfigurasi dinding geser yang optimal, merencanakan elemen struktur, serta menghitung Rencana Anggaran Biaya (RAB). Pemodelan dilakukan menggunakan ETABS berdasarkan SNI 1726:2019, SNI 2847:2019, dan SNI 1727:2020 terhadap lima model, terdiri atas satu model SRPMK dan empat model Sistem Ganda dengan konfigurasi dinding geser berbeda. Analisis gempa menggunakan metode respons spektrum dengan mengevaluasi periode getar, gaya geser dasar, simpangan antar-lantai, stabilitas P-Delta, partisipasi massa, dan persyaratan Sistem Ganda. Hasil evaluasi menunjukkan Variasi 1 sebagai alternatif terpilih, dengan kontribusi SRPMK sebesar 59,92% pada arah X dan 69,60% pada arah Y, sedangkan dinding geser berkontribusi sebesar 40,08% dan 30,40%. Simpangan antar-lantai maksimum sebesar 30,003 mm pada arah X dan 36,355 mm pada arah Y, masih di bawah batas izin 61,538 mm, dengan koefisien stabilitas P-Delta di bawah 0,10. Perencanaan meliputi pelat, balok, kolom, dan dinding geser dengan estimasi biaya sebesar Rp9.891.803.653. Hasil penelitian menunjukkan bahwa konfigurasi dinding geser memengaruhi kinerja struktur terhadap gempa sehingga pemilihannya perlu mempertimbangkan kontribusi gaya lateral, simpangan, dan stabilitas struktur.

References

  1. [1] Amir, A. Y. A., & Wiswamitra, K. A. (2024). Comparison of Behavior of Reinforced Concrete Dual-system Structure (Frame-Shear Wall) and Steel Dual-system Structure (Frame-Special Plate Shear Wall) in High Rise Building (Case Study: IT Mandiri Bumi Slipi Building). Rekayasa Sipil, 18(3), 272-280.
  2. [2] Hendra, H., Zulkarnaen, L. V., Rosanti, I., & Ariyansyah, R. (2021). Analisis Struktur Gedung Tahan Gempa Dengan Metode Sistem Ganda (Dual System). Construction and Material Journal, 3(3), 189-196.
  3. [3] Değer, Z. T., & Wallace, J. W. (2016). Seismic performance of reinforced concrete dual‐system buildings designed using two different design methods. The structural design of tall and special buildings, 25(1), 45-59.
  4. [4] Suwal, R., & Khawas, A. (2022). Performance of Reinforced Concrete Shear Wall In Dual Structural System: A Review. Nepal Journal of Science and Technology, 21(1), 91-100.
  5. [5] El Zareef, M. A., Ghalla, M., Hu, J. W., & El-Demerdash, W. E. (2024). Damage detection of lightweight concrete dual systems reinforced with GFRP bars considering various building heights and earthquake intensities. Case Studies in Construction Materials, 20, e03191.
  6. [6] Putra, O. B., Ramadhan, I. D., Rosyidah, A., Saputra, J., & Sucita, I. K. (2024). Investigation of seismic resistant structures with various moment-resisting frame systems and pushover analysis. Sinergi (Indonesia), 28(3), 535-544.
  7. [7] Moehle, J. P., Hooper, J. D., & Lubke, C. D. (2016). Seismic design of reinforced concrete special moment frames. US Department of Commerce, National Institute of Standards and Technology.
  8. [8] Teddy, L., & Tumbelaka, H. H. (2025). A Shear Wall Design Study in an 8-Story Building. Journal of Architectural Design and Urbanism, 7(2), 61-69.
  9. [9] Seçkin, A. (2025). Influence of shear wall layout on the seismic performance of an RC building. Journal of Innovative Engineering and Natural Science, 5(2), 751-764.
  10. [10] Masheh, O. H. F., & Al-lami, M. S. (2022). THE MOST SUITABLE SEISMIC STRUCTURAL SYSTEMS IN HIGH-RISE REINFORCED CONCRETE BUILDINGS. GEOMATE Journal, 23(95), 65-72.
  11. [11] Faizah, R. (2015). Studi Perbandingan Pembebanan Gempa Statik Ekuivalen dan Dinamik Time History pada Gedung Bertingkat di Yogyakarta. Semesta Teknika, 18(2), 190-199.
  12. [12] Xiong, Z., Liang, J., & Chen, X. (2025). Seismic Performance Evaluation of Reinforced Concrete Frame–Shear Wall Structural Systems in Thermal Power Plants. Buildings, 15(3), 419. https://doi.org/10.3390/buildings15030419
  13. [13] Paulay, T., & Priestley, M. N. (1992). Seismic design of reinforced concrete and masonry buildings (Vol. 768). New York: Wiley.
  14. [14] Darwin, D., Dolan, C. W., & Nilson, A. H. (2016). Design of concrete structures (Vol. 2). New York, NY, USA: McGraw-Hill Education.
  15. [15] Safety, I. S. (2004). NEHRP recommended provisions for seismic regulations for new buildings and other structures (FEMA 450). Building Seismic Safety Council, National Institute of Building Sciences: Washington, DC, USA.

Similar Articles

131-140 of 364

You may also start an advanced similarity search for this article.